Rohde & Schwarz FSW13, User Manual

Page: 676 / 1150

Remote Commands
R&S
®
FSW
676 User Manual 1173.9411.02 ─ 19
11 Remote Commands
The commands required to perform measurements in the Spectrum application in a
remote environment are described here.
It is assumed that the R&S FSW has already been set up for remote operation in a net-
work as described in chapter 10.5, "How to Set Up a Network and Remote Control" ,
on page 657.
Compatibility with former R&S signal and spectrum analyzers
As a rule, the R&S FSW supports most commands from previous R&S signal and
spectrum analyzers such as the FSQ, FSP, FSU, or FSV. However, the default values,
in particular the number of sweep points or particular bandwidths, may vary. Therefore,
the R&S
FSW can emulate these other devices, including their default values, in order
to repeat previous measurements or support existing control applications as in legacy
systems.
● Conventions used in SCPI Command Descriptions ..............................................676
● Common Suffixes ..................................................................................................677
● Common Commands ............................................................................................ 677
● Selecting the Operating Mode and Application .....................................................682
● Configuring and Performing Measurements ......................................................... 692
● Configuring the Result Display ..............................................................................821
● Setting Basic Measurement Parameters ...............................................................830
● Analyzing Measurements (Basics) ........................................................................907
● Managing Settings and Results ............................................................................ 990
●
Configuring the R&S FSW .................................................................................. 1018
● Using the Status Register ................................................................................... 1044
● Commands for Remote Instrument Operation .................................................... 1048
● Emulating Other Instruments' Commands .......................................................... 1049
● Commands for Compatibility ...............................................................................1085
● Programming Examples ......................................................................................1087
11.1 Conventions used in SCPI Command Descriptions
Note the following conventions used in the remote command descriptions:
●
Command usage
If not specified otherwise, commands can be used both for setting and for querying
parameters.
If a command can be used for setting or querying only, or if it initiates an event, the
usage is stated explicitely.
●
Parameter usage
If not specified otherwise, a parameter can be used to set a value and it is the
result of a query.
Parameters required only for setting are indicated as
Setting parameters .
Parameters required only to refine a query are indicated as Query parameters .
Conventions used in SCPI Command Descriptions