Rohde & Schwarz FSW13, User Manual

Page: 545 / 1150

Data Management
R&S
®
FSW
545 User Manual 1173.9411.02 ─ 19
Recall
Restores the instrument settings as saved in the selected settings file. If the settings
file contains settings for a specific channel only a new channel with the stored settings
is activated, otherwise the entire instrument settings are loaded.
Note: After you use the "Recall" function, the history of previous actions is deleted, i.e.
any actions performed previously cannot be undone or redone using the UNDO/REDO
keys.
Note: If a measurement channel with the same name as the channel to be restored (in
a new channel) is already active, the channel name for the new channel is extended by
a consecutive number:
In remote commands, you must append this number to the channel name, as well.
Remote command:
MMEMory:
​
LOAD:
​
STATe
​
on page 1001
Cancel
Closes the dialog box without saving the settings.
8.3.2 Configurable Storage and Recall
The more sophisticated storage and recall functions allow you to define which settings
are stored, and where the settings file is stored to. Any settings file can be selected for
recall.
● Stored Data Types ................................................................................................ 545
● Storage Location and File Name ...........................................................................546
● Save and Recall Dialog Boxes ..............................................................................546
● Startup Recall Settings ..........................................................................................549
8.3.2.1 Stored Data Types
The following types of data can be stored to and loaded from files via the "Save" dialog
box on the R&S
FSW:
Table 8-2: Items that can be stored to files
Item Description
Current Settings Current instrument and measurement settings
All Transducers Transducer factors for all active transducers.
All Traces
All active traces; R&S FSW-K30 only: also calibration data
All Limit Lines All limit lines (Note: information on which limit lines are active is stored with
the "Current Settings")
Noise - ENR
Data in "ENR Settings" dialog box (R&S FSW-K30 only)
Noise - Loss Settings Data in "Loss Settings" dialog box (R&S FSW-K30 only)
Storing and Recalling Instrument Settings and Measurement Data