Common Analysis and Display Functions
R&S
®
FSW
478
User Manual 1173.9411.02 ─ 19
How to Copy Traces
1. A trace copy function is provided in a separate tab of the "Traces" dialog box. To
display this tab do one of the following:
● Select the TRACE key and then the "Trace Copy" softkey.
● Select "Analysis" from the "Overview", then select the "Trace Copy" tab.
2. Select the "Source" trace to be copied.
3. Select the "Copy to trace..." button for the trace to which the settings are to be
applied.
The settings from the source trace are applied to the destination trace. The newly
configured trace (if not set to "Blank") is displayed after the next sweep.
7.3.3.2
How to Display and Configure a Spectrogram
Step-by-step instructions on how to display and configure a spectrogram are provided
here. For details on individual functions and settings see
The remote commands required to perform these tasks are described in
ter 11.8.2.2, "Configuring Spectrograms"
The following tasks are described here:
●
●
"To remove the spectrogram display"
●
"To set a marker in the spectrogram"
●
●
●
"To set the value range graphically using the color range sliders"
●
"To set the value range numerically"
●
"To set the color curve shape graphically using the slider"
●
"To set the color curve shape numerically"
To display a spectrogram
1. In the "Overview", select "Display", then drag the evaluation type "Spectrogram" to
the diagram area.
Alternatively:
a) Select the TRACE key and then the "Spectrogram Config" softkey.
b) Toggle "Spectrogram" to "ON".
2. To clear an existing spectrogram display, select "Clear Spectrogram".
3. Start a new measurement using RUN SINGLE or RUN CONT.
The spectrogram is updated continuously with each new sweep.
4. To display the spectrum diagram for a specific time frame:
Trace Configuration
