Rohde & Schwarz FSW13, User Manual

Page: 382 / 1150

Common Measurement Settings
R&S
®
FSW
382 User Manual 1173.9411.02 ─ 19
IF/VIDEO/DEMOD Output ...........................................................................................382
IF (Wide) Out Frequency .............................................................................................383
Noise Source ...............................................................................................................383
Trigger 2/3 ...................................................................................................................383
└ Output Type .................................................................................................. 383
└ Level ................................................................................................... 384
└ Pulse Length .......................................................................................384
└ Send Trigger ....................................................................................... 384
IF/VIDEO/DEMOD Output
Defines the type of signal available at the IF/VIDEO/DEMOD or IF OUT connector on
the rear panel of the R&S FSW.
For restrictions and additional information see chapter 6.2.1.6, "IF and Video Signal
Output" , on page 317.
"IF" The measured IF value is available at the IF/VIDEO/DEMOD output
connector.
The frequency at which this value is available is defined in
"IF (Wide)
Out Frequency" on page 383.
"IF 2 GHz Out" The measured IF value is available at the IF
OUT output connector at
a frequency of 2 GHz (with a bandwidth of 2 GHz).
This setting is only available for instrument models
R&S
FSW43/50/67.
For further prerequisites see "IF 2 GHz Output" on page 318.
"VIDEO" The displayed video signal (i.e. the filtered and detected IF signal) is
available at the IF/VIDEO/DEMOD output connector.
This setting is required to provide demodulated audio frequencies at
the output.
Remote command:
OUTPut:
​
IF[:
​
SOURce]
​
on page 904
OUTPut:
​
IF:
​
SBANd?
​
on page 905
Data Input and Output