Rohde & Schwarz FSV3000, User Manual

Page: 783 / 1489

Network operation and remote control
R&S
®
FSVA3000/ R&S
®
FSV3000
783 User Manual 1178.8520.02 ─ 08
Bit No. Meaning
4 "TEMPerature"
This bit is set if the temperature is questionable.
5 "FREQuency"
This bit is set if there is anything wrong with the frequency of the local oscillator or the reference
frequency in any of the active channels.
The STATus:QUEStionable:FREQuency register provides more information on the error type.
6 - 7 Unused
8 "CALibration"
This bit is set if the R&S FSV/A is unaligned ("UNCAL" display)
9 "LIMit" (device-specific)
This bit is set if a limit value is violated in any of the active channels in any window.
The STATus:QUEStionable:LIMit register provides more information on the error type.
10 "LMARgin" (device-specific)
This bit is set if a margin is violated in any of the active channels in any window.
The STATus:QUEStionable:LMARgin register provides more information on the error type.
11 "SYNC" (device-specific)
This bit is set if the R&S FSV/A is not synchronized to the signal that is applied.
The R&S FSV/A is not synchronized if:
●
it cannot synchronize to midamble during a measurement or premeasurement
●
it cannot find a burst during a measurement or premeasurement
●
the results deviate too much from the expected value during premeasurements
12 "ACPLimit" (device-specific)
This bit is set if a limit during ACLR measurements is violated in any of the active channels.
The STATus:QUEStionable:ACPLimit register provides more information on the error type.
13
13-14
Unused
15 This bit is always 0.
11.2.2.6 STATus:QUEStionable:ACPLimit register
The STATus:QUEStionable:ACPLimit register contains information about the results of
a limit check during ACLR measurements. A separate ACPLimit register exists for
each active channel.
You can read out the register with
STATus:QUEStionable:ACPLimit:CONDition?
or
STATus:QUEStionable:ACPLimit[:EVENt]?
Status reporting system