Rohde & Schwarz FPL1000 Series, User Manual

Page: 682 / 899

Remote Commands
R&S
®
FPL1000
682 User Manual 1178.3370.02 ─ 03
Output functions require the option R&S FPL1-B5 to be installed on the R&S FPL1000.
DIAGnostic:SERVice:NSOurce
........................................................................................682
OUTPut:IF[:SOURce]
..................................................................................................... 682
OUTPut:IF:IFFRequency
................................................................................................ 683
OUTPut:UPORt:STATe
.................................................................................................. 683
OUTPut:UPORt[:VALue]
................................................................................................. 683
OUTPut:UPORt:WTRigger:POLarity
................................................................................ 684
SYSTem:SPEaker[:STATe]
.............................................................................................684
SYSTem:SPEaker:VOLume
............................................................................................684
DIAGnostic:SERVice:NSOurce <State>
This command turns the 28 V supply of the BNC connector labeled NOISE SOURCE
CONTROL on the R&S
FPL on and off.
Suffix:
<n>
.
Window
Parameters:
<State> ON | OFF | 1 | 0
*RST:
0
Example: DIAG:SERV:NSO ON
Manual operation: See "Noise Source Control" on page 374
OUTPut:IF[:SOURce] <Source>
Defines the type of signal available at the IF/VIDEO connector of the R&S FPL.
Parameters:
<Source> IF
The measured IF value is available at the IF/VIDEO output con-
nector.
The frequency at which the IF value is provided is defined using
the
OUTPut:IF:IFFRequency
command.
VIDeo
The displayed video signal (i.e. the filtered and detected IF sig-
nal, 200mV) is available at the IF/VIDEO output connector.
This setting is required to provide demodulated audio frequen-
cies at the output.
*RST:
IF
Example: OUTP:IF VID
Selects the video signal for the IF/VIDEO output connector.
Manual operation: See "Data Output" on page 374
Setting Basic Spectrum RF Measurement Parameters