Rohde & Schwarz FPL1000 Series, User Manual

Page: 640 / 899

Remote Commands
R&S
®
FPL1000
640 User Manual 1178.3370.02 ─ 03
//-------------- Preparing the configuration from example 1 -----------
*RST
LAY:ADD? '1',BEL,SGR
LAY:ADD? '1',RIGH,MTAB
LAY:WIND2:ADD? RIGH,PEAK
LAY:CAT?
//Result : '1',1,'2',2,'3',3,'4',4
//Remove Spectrogram
LAY:WIND2:REM //Remove Marker Table window
LAY:REM '3'
//Replace Marker Peak List window by Marker Table
LAY:REPL '4',MTAB
//--------------- Querying all displayed windows ------------------
//Query the name and number of all displayed windows (from top left to bottom right)
LAY:CAT?
//Result : '1',1,'4',4
//--------------- Changing the size of individual windows -------------
//Move the splitter between the Frequency Sweep window and the Marker Table window
//to enlarge the spectrum display to 80% of the entire height.
LAY:SPL 1,4,80
8.8 Setting Basic Spectrum RF Measurement Parameters
Commands required for common spectrum RF measurements are described here.
● Defining the Frequency and Span .........................................................................641
● Configuring Bandwidth and Sweep Settings .........................................................650
● Configuring the Vertical Axis (Amplitude, Scaling) ................................................656
● Configuring Triggered and Gated Measurements .................................................662
● Configuring the Data Input and Output ................................................................. 669
● Zooming into the Display .......................................................................................685
Setting Basic Spectrum RF Measurement Parameters