Rohde & Schwarz FPL1000 Series, User Manual

Page: 575 / 899

Remote Commands
R&S
®
FPL1000
575 User Manual 1178.3370.02 ─ 03
[SENSe:]ESPectrum<sb>:RANGe<range>:LIMit<PClass>:RELative:STOP:
FUNCtion <Function>
This command enables the use of a function when defining the relative limit for a SEM
range.
Suffix:
<sb>
.
1 | 2 | 3
<range> 1..30
Selects the SEM range.
<PClass> 1..4
Power class for which the limit is defined.
Parameters:
<Function> Defines the function to be used to determine the relative limit
line stop value
MAX
The maximum of the relative and the absolute level is used as
the limit stop value. Use the
[SENSe:]ESPectrum<sb>:
RANGe<range>:LIMit<PClass>:RELative:STOP
and
[SENSe:]ESPectrum<sb>:RANGe<range>:
LIMit<PClass>:RELative:STOP:ABS
commands to define
these values.
OFF
No function is used, the relative limit line is defined by a fixed
relative stop value. Use the
[SENSe:]ESPectrum<sb>:
RANGe<range>:LIMit<PClass>:RELative:STOP
com-
mand to define this value.
*RST:
OFF
Example: SENSe:ESPectrum:RANGe:LIMit:RELative:STOP:
FUNCtion MAX
For a detailed example see Chapter 8.6.6.10, "Example: SEM
Measurement" , on page 587.
Manual operation: See " Rel Limit Start / Stop <n> " on page 305
[SENSe:]ESPectrum<sb>:RANGe<range>:LIMit<PClass>:STATe <State>
This command selects the limit check mode for all SEM ranges (<range> is irrelevant).
Suffix:
<sb>
.
1 | 2 | 3
<PClass> 1..4
Power class for which the limit is defined.
Configuring and Performing Measurements