Rohde & Schwarz FPL1000 Series, User Manual

Page: 367 / 899

The Spectrum Application (RF Measurements)
R&S
®
FPL1000
367 User Manual 1178.3370.02 ─ 03
State ...........................................................................................................................367
Continuous Value Update .......................................................................................... 368
Select ......................................................................................................................... 368
Zeroing Power Sensor ............................................................................................... 368
Frequency Manual ..................................................................................................... 368
Frequency Coupling ................................................................................................... 368
Unit/Scale ...................................................................................................................369
Meas Time/Average ................................................................................................... 369
Setting the Reference Level from the Measurement Meas -> Ref ............................. 369
Reference Value ........................................................................................................ 369
Use Ref Level Offset .................................................................................................. 369
Average Count ( Number of Readings ) ......................................................................370
Duty Cycle ..................................................................................................................370
Using the power sensor as an external trigger ...........................................................370
└ External Trigger Level ..................................................................................370
└ Hysteresis .................................................................................................... 370
└ Trigger Holdoff ............................................................................................. 371
└ Drop-Out Time ............................................................................................. 371
└ Slope ............................................................................................................371
State
Switches the power measurement for all power sensors on or off. Note that in addition
to this general setting, each power sensor can be activated or deactivated individually
by the
Select setting on each tab. However, the general setting overrides the individual
settings.
Remote command:
[SENSe:]PMETer<p>[:STATe]
on page 678
Receiving Data Input and Providing Data Output