Rohde & Schwarz EVSG-B1, User Manual

Page: 85 / 418

Numeric Measurement Modes
R&S
®
EVSG1000
85 User Manual 1178.6227.02 ─ 06
FFT_BB_LFIN_DCOFFSETV
on page 362
SCOPE_BB_LFIN_DCOFFSETV
on page 369
LF In Factor
Access
: [AMPT]
Access VNC : [w]
Applies a factor to the measured power levels, e.g. to compensate certain effects in the
input system.
Remote command:
SETUP:BB_IN_FACTOR
on page 250
Bandwidth (IF BW/AF In BW)
Access
: [BW]
Access VNC : [e]
Bandwidth with which the LF input is aquired. The default bandwidth is 3 kHz for Low
IF measurements. For AF measurements, the default bandwidth is 1.5 kHz.
Remote command:
AF mode:
LLZ_BB_BW_KHZ
on page 276
GS_BB_BW_KHZ
on page 285
VOR_BB_BW_KHZ
on page 313
Low IF mode:
LLZ_BB_LOWIF_BW_KHZ
on page 277
GS_BB_LOWIF_BW_KHZ
on page 286
IF/AF Bandwidth (Dist/ID)
Access
: [BW]
Access VNC : [e]
Bandwidth with which the ID analysis and distortion measurement is performed. The
default bandwidth is 3
kHz for Low IF measurements. For AF measurements, the
default bandwidth is 1.5 kHz.
Remote command:
AF mode:
LLZ_BB_AF_BW_IDDIST_KHZ
on page 276
GS_BB_AF_BW_IDDIST_KHZ
on page 285
Low IF mode:
GS_BB_LOWIF_BW_IDDIST_KHZ
on page 286
LLZ_BB_LOWIF_BW_IDDIST_KHZ
on page 277
Res. FM Filt.
Access
: [BW]
Access VNC : [e]
Defines the filter type used to determine residual FM (see Chapter 4.1.3.5, "ILS Local-
izer Distortion View" , on page 69).
"ICAO" Filter according to ICAO specification
ILS Localizer and ILS Glidepath (GP) Modes