Rohde & Schwarz ESRP Series, User Manual

Page: 814 / 1094

Remote Control
R&S
®
ESRP
811 User Manual 1175.7445.02 ─ 08
[SENSe:]SWEep:EGATe:TYPE <Type>
This command sets the type of triggering by the external gate signal.
A delay between applying the gate signal and the start of recording measured values
can be defined, see
[SENSe:]SWEep:EGATe:HOLDoff
on page 809.
Parameters:
<Type> LEVel | EDGE
LEVel
The gate is level-triggered:
After detection of the gate signal, the gate remains open until the
gate signal disappears. The gate opening time cannot be
defined with the command
[SENSe:]SWEep:EGATe:HOLDoff
.
Note : Using gating with gate mode "level" and an IFP trigger
(see
TRIGger<n>[:SEQuence]:SOURce
on page 807), the
holdoff time for the IFP trigger is ignored for frequency sweep,
FFT sweep, zero span and IQ mode measurements.
EDGE
The gate is edge-triggered:
After detection of the set gate signal edge, the gate remains
open until the gate delay (
[SENSe:]SWEep:EGATe:HOLDoff
)
has expired.
*RST:
EDGE
Example: SWE:EGAT:TYPE EDGE
Manual operation: See "Gate Mode (Lvl/Edge)" on page 350
11.5.2.6 Vertical Axis Configuration
The following commands configure the characteristics of the vertical diagram axis.
Commands useful to configure the vertical axis described elsewhere:
●
DISPlay[:WINDow<n>]:TRACe<t>:Y:SPACing
on page 636
●
INPut:ATTenuation
on page 637
●
INPut:COUPling
on page 641
●
INPut:GAIN:STATe
on page 638
●
INPut:IMPedance
on page 638
CALCulate<n>:UNIT:POWer
........................................................................................... 812
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]
................................................................... 812
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]:MODE
.........................................................812
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]:RLEVel
........................................................813
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]:RLEVel:OFFSet
........................................... 813
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]:RPOSition
................................................... 814
INPut:ATTenuation:AUTO
............................................................................................... 814
UNIT<n>:POWer
............................................................................................................814
Remote Commands in Spectrum Analyzer Mode