Quick Start
R&S
®
ESRP
32
User Manual 1175.7445.02 ─ 08
The probe power connector on the left supports supply voltages of
±
10
V and ground.
The maximum permissible current is 200
mA. This probe power connector is suitable,
for example, for transducers from Rohde
&
Schwarz.
The probe power connector on the right supports supply voltages from +15
V to
-12.6
V and ground. The maximum permissible current is 150
mA. This probe power
connector is suitable, for example, for high-impedance probes from Agilent.
AF OUTPUT
Headphones equipped with a miniature jack plug can be connected to the AF output
female connector. The internal impedance is 10
Ω. The output voltage can be set by
using the volume control to the right of the female connector. If a plug is connected, the
internal loudspeaker is automatically switched off.
Risk of hearing damage
Before putting on the headphones, make sure that the volume setting is not too high to
protect your hearing.
3.1.1.4
Optional Front Panel Connectors
Tracking Generator Output (GEN OUTPUT 50
Ω, Option R&S
FSV-B9)
The R&S
ESRP is equipped with an optional tracking generator and therefore provides
a tracking generator output connector.
The output of the tracking generator is connected to the DUT via a cable equipped with
a male N connector. The female connector is available only with the tracking generator
option (R&S
FSV-B9).
Risk of damaging the tracking generator
To avoid damaging the tracking generator, make sure that the reverse power (i.e. input
power caused, for example, by reflections in the test setup) never exceeds 1
W RF
power. Do not apply a DC voltage at the output.
For details, refer to the data sheet.
Sensitive DUTs concerning matching
For DUTs with sensitive RF characteristics with regard to matching (VSWR) at the
input, insert a 10
dB attenuator between the DUT and the tracking generator.
Front and Rear Panel View
