Spectrum Measurements
R&S
®
ESRP
315
User Manual 1175.7445.02 ─ 08
Parameter
Setting
noise source
off
input
RF
6.2.2
Selecting the Frequency and Span – FREQ Key
The FREQ key is used to configure the frequency axis, to set the frequency offset and
the signal track function. You can configure the frequency axis either by the start and
stop frequency or the center frequency and the span.
To open the Frequency menu
●
Press the [FREQ] key.
The "Frequency" menu is displayed. The "Frequency Center" edit dialog box is dis-
played.
Menu and softkey description
●
Chapter 6.2.2.1, "Softkeys of the Frequency Menu"
Tasks
●
Chapter 6.2.2.2, "Specifying the Frequency Axis by the Start and Stop Frequency"
●
Chapter 6.2.2.3, "Specifying the Frequency Axis by the Center Frequency and the
Span"
●
Chapter 6.2.2.4, "Specifying the Step Size for the Arrow Keys and the Rotary
Knob"
●
Chapter 6.2.2.5, "Modifying the Frequency Axis by an Offset"
●
Chapter 6.2.2.6, "Tracking Signals (Span > 0)"
6.2.2.1
Softkeys of the Frequency Menu
The following chapter describes all softkeys available in the "Frequency" menu. It is
possible that your instrument configuration does not provide all softkeys. If a softkey is
only available with a special option, model or (measurement) mode, this information is
provided in the corresponding softkey description.
......................................................................................316
......................................................................................316
......................................................................................317
......................................................................................317
......................................................................................... 317
......................................................................................... 317
Configuration