Rohde & Schwarz ESRP Series, User Manual

Page: 135 / 1094

Receiver Mode
R&S
®
ESRP
132 User Manual 1175.7445.02 ─ 08
5.1.7 Measurement Control
Measurements in receiver mode allow you to control the course of the measurement.
This way, you can make use of the automated test sequences but still be able to
change the setup once the test sequence is already running.
● Running Scans and Measurements ......................................................................132
● Selecting the Result Display ................................................................................. 132
● Bargraph Control ...................................................................................................133
● Scan Control ......................................................................................................... 134
● Final Measurement Control ...................................................................................136
● Measurement Settings .......................................................................................... 138
● Spectrogram Configuration ................................................................................... 140
5.1.7.1 Running Scans and Measurements
The [RUN SINGLE] and [RUN CONT] hardkeys initiate scans and measurements.
●
RUN SINGLE starts a single scan or measurement. A single measurement lasts
until the defined frequency range has been measured once under the configured
conditions. When it has finished, the measurement stops.
In case of measurements in the time domain, a single measurement lasts until the
defined measurement time has passed.
●
RUN CONT starts a continuous scan or measurement. A continuous measurement
lasts until it is interrupted or stopped.
SCPI command:
INITiate<n>:CONTinuous
on page 609
INITiate<n>[:IMMediate]
on page 610
5.1.7.2 Selecting the Result Display
The R&S ESRP allows you to display the results in various combinations.
You can display up to three results simultaneously, for example the Bargraph, the Scan
diagram and the Spectrogram.
The "Meas" menu contains the basic measurement settings and the selection of result
displays.
► Press the [MEAS] key.
The R&S ESRP opens the "Meas" menu.
► Press the "More Display Options" softkey.
The submenu contains more result displays.
Note that the Spectrogram is available for the Scan display and the IF Analysis. To add
the Spectrogram, either Scan or IF Analysis have to be turned on already. If you are
using the Scan and IF Analysis simultaneously, the Spectrogram is unavailable.
Measurements and Result Displays