Rohde & Schwarz CMW-KE100, User Manual

Page: 500 / 938

CDMA2000 Signaling
R&S
®
CMW-KM8xx/-KS8xx
500 User Manual 1173.9511.02 ─ 12
Fig. 4-7: Connection status area in the main view
For background information about the displayed states, see chapter 4.2.8, "Connection
States" , on page 466.
For control of the states, see chapter 4.3.2, "Signaling Control" , on page 513.
Cell .............................................................................................................................. 500
Mobile Station ............................................................................................................. 500
RX Power .................................................................................................................... 500
1st Service Option .......................................................................................................501
Voice Coder ................................................................................................................ 501
Radio Configuration .................................................................................................... 501
MUX Options ...............................................................................................................501
SCH0 Data Rate ......................................................................................................... 501
Cell
Indicates the overall state of the cell (green = on, gray = off, additional = pending).
Remote command:
SOURce:CDMA:SIGN<i>:STATe
SOURce:CDMA:SIGN<i>:STATe:ALL?
Mobile Station
Provides a current connection state of MS. See chapter 4.2.8, "Connection States" ,
on page 466.
Remote command:
FETCh:CDMA:SIGN<i>:SOPTion:STATe?
RX Power
Indicates the quality of the received power in reverse link:
●
- - - : no signal from MS detected; the MS may be switched off or in idle mode.
●
in range : the MS power is in the expected range, according to the expected power
mode and expected power, see chapter 4.3.7.3, "RF Power Settings" ,
on page 526.
Accurate measurements can be performed in this state.
●
overdriven : the MS power is above the expected range. An inappropriate external
attenuation may be set, or the MS may not transmit at the correct power.
GUI Reference
深圳德标仪器
135-1095-0799