Rohde & Schwarz AREG100A, User Manual, Page: 196 / 321

Remote Control Commands
R&S
®
AREG100A
196 User Manual 1178.7417.02 ─ 04
Query parameters:
<Board> string
Module name, as queried with the command
:
DIAGnostic<hw>:BGINfo:CATalog?
.
To retrieve a complete list of all modules, omit the parameter.
The length of the list is variable and depends on the instrument
equipment configuration.
Return values:
<BgInfo> <Module name> <Module stock number incl. variant> <Module
revision> <Module serial number>
List of comma-separated entries, one entry per module.
Each entry for one module consists of four parts that are separa-
ted by space characters.
Example: See Example "Programming example" on page 195.
Usage: Query only
Manual operation: See "Assembly" on page 278
:DIAGnostic<hw>:POINt:CATalog?
Queries the test points available in the instrument.
For more information, see R&S AREG100A Service Manual.
Return values:
<Catalog> string
List of comma-separated values, each representing a test point
Example: See Example "Programming example" on page 195.
Usage: Query only
:DIAGnostic<hw>[:MEASure]:POINt? <Name>
Triggers the voltage measurement at the specified test point and returns the measured
voltage.
For more information, see R&S AREG100A Service Manual.
Query parameters:
<Name> <test point identifier>
Test point name, as queried with the command
:
DIAGnostic<hw>:POINt:CATalog?
Return values:
<Value> <value><unit>
Example: See Example "Programming example" on page 195.
Usage: Query only
DIAGnostic Subsystem