Rohde & Schwarz 6144.7800.02, Operating Manual

Page: 182 / 189

Remote Control Commands R&S EU4200C
6.11 6174.8456.02-01
6.3 Remote Control Commands
List of Rem ote Contro l Com m ands\Li st of Rem ote Control Com m ands " Radio". doc
The radio can be remotely controlled and monitored via its IP-interface.
Remote control is possible either via SNMP or the Rohde & Schwarz
GB2PP protocol. SNMP and GB2PP can be used in parallel, with a
maximum of 4 remote control clients, having an active connection (TCP for
GB2PP, UDP for SNMP). However, when using GB2PP/TCP only, a
maximum of 6 remote control clients is permitted.
With respect to SNMP, the Series 4200 radio provides a full implementation
of the Generic ATC Radio MIB according to ED137B Volume 5
"Supervision" and supports relevant MIB-II objects as specified in RFC
1213, in addition to its own Radio specific MIB.
SNMPv3 USM features (User-Based Security Model, RFC 3414), e.g. user
authentication, and fine-grained access control via VACM (View-Based
Access Control Model, RFC 3415) are available to the user if the parameter
"SNMP Enable" is active. SNMPv3 configuration tasks can be performed
based on the existing SNMP admin user (username: "InitialUser",
Password: "InitialUser") as starting point and based on USM and VACM
MIB commands.
The S4200 radio persistently stores the SNMPv3 user configuration. To
restore the empty default configuration with the initial user, it is necessary to
(temporarily) deactivate SNMP via the parameter "SNMP Enable".
Note:
The MIBs are available on request.