Connecting the Probe to the DUT
R&S
®
RT-ZPR20
R&S
®
RT-ZPR40
20
User Manual 1800.5035.02 ─ 03
Risk of injuries
Always observe the maximum rating of
±
60
V
DC, 30
V
AC (RMS), or
±
42
V
AC (peak). The R&S RT-ZA25 is not equipped with a protective
impedance and must not be used to measure higher voltages.
The included browser pins are exceptionally sharp and must be handled
with extreme care. To prevent injuries, always use tweezers when inserting
or removing pins.
To avoid damaging the browser parts, use them carefully:
●
Do not apply a side load to the browser.
●
Do not apply too much force when browsing. The weight of the probe in your
hand is sufficient.
●
Always remove the browser from the DUT before disconnecting the probe
from the oscilloscope.
Connect the R&S RT-ZA25 power rail browser
to the SMA interface of the R&S
RT-ZPR20/40
probe box. You can use the browser in the
same way as conventional passive probes.
Bandwidth: >350
MHz
Length: 1
m
Temperature range: 0
°C to +40
°C
For highest bandwidth and signal integrity, use
the ground spring and spring loaded or rigid
signal tips.
R&S RT-ZA25 Power Rail Browser Kit
