Rohde & Schwarz 1440.8002.02, Getting Started

Page: 41 / 95

Instrument tour
R&S
®
SMM100A
41 Getting Started 1179.1335.02 ─ 04
Use this interface to connect a computer for remote control of the
R&S
SMM100A. To set up the connection, use high-quality shielded cables. See
"Cable selection and electromagnetic interference (EMI)" on page 19.
See also "Annex: Hardware Interfaces" and chapter "Network and Remote Con-
trol" in the user manual.
System drive (HDD)
Hard disk drive (HDD) or solid-state drive (SSD); the SSD requires option
R&S
SMM-B93.
For security reasons, the hard disk is bound to the specific R&S SMM100A. You
can remove it from the instrument, but you cannot use it in other instruments.
See also section "Removing the system drive from the R&S
SMM100A" in the
user manual.
AC power supply connector and switch
Mains power switch for performing the following tasks:
●
Connecting the internal power supply to the power source
●
Disconnecting the internal power supply from the power source
How to: Chapter 3.6, "Connecting to power" , on page 20.
USB/USB Device
●
Two female USB (universal serial bus) 3.1 connectors of type A (host USB), to
connect devices like a keyboard, a mouse, a memory stick, or the R&S NRP-
Z3/Z4 cable for the R&S NRP power sensors.
●
Female USB 3.0 connector of type B (USB Device), for example, for remote
control.
How to: Chapter 3.8, "Connecting USB devices" , on page 21
LAN
RJ-45 connector to connect the R&S SMM100A to a LAN for remote control,
remote operation, and data transfer.
How to:
Chapter 3.7, "Connecting to LAN" , on page 20
Display Port, HDMI
Provided for future use.
Dig I/Q
Connectors for the input of a digital I/Q signal from a Rohde & Schwarz instru-
ment, like a signal generator.
Rear panel tour