Rohde & Schwarz 1440.8002.02, Getting Started

Page: 16 / 95

Preparing for use
R&S
®
SMM100A
16 Getting Started 1179.1335.02 ─ 04
3.3 Choosing the operating site
Specific operating conditions ensure proper operation and avoid damage to the
product and connected devices. For information on environmental conditions
such as ambient temperature and humidity, see the data sheet.
See also "Choosing the operating site" on page 8.
Electromagnetic compatibility classes
The electromagnetic compatibility (EMC) class indicates where you can operate
the product. The EMC class of the product is given in the data sheet under "Gen-
eral data".
●
Class B equipment is suitable for use in:
– Residential environments
– Environments that are directly connected to a low-voltage supply network
that supplies residential buildings
●
Class A equipment is intended for use in industrial environments. It can cause
radio disturbances in residential environments due to possible conducted and
radiated disturbances. It is therefore not suitable for class B environments.
If class
A equipment causes radio disturbances, take appropriate measures to
eliminate them.
3.4 Setting up the R&S SMM100A
See also:
●
"Setting up the product" on page 8
●
"Intended use" on page 7
3.4.1 Placing the R&S SMM100A on a bench top
To place the product on a bench top
1. Place the product on a stable, flat and level surface. Ensure that the surface
can support the weight of the product. For information on the weight, see the
data sheet.
Setting up the R&S SMM100A