Rohde & Schwarz 1424.7805K02, User Manual

Page: 127 / 530

Sensor configuration
R&S
®
NRX
127 User Manual 1178.5566.02 ─ 09
Range State ................................................................................................................ 127
Range ..........................................................................................................................127
User Defined Transition ...............................................................................................127
Offset ...........................................................................................................................128
Attenuator Mode ..........................................................................................................128
Attenuation .................................................................................................................. 128
Range State
Enables or disables the automatic measurement path selection.
Remote command:
CALCulate<Measurement>[:CHANnel<Channel>][:POWer][:AVG]:RANGe:
AUTO
on page 349
Range
Available if Range State is set to "User".
Sets the active measurement path in which the power sensor is measuring.
Remote command:
CALCulate<Measurement>[:CHANnel<Channel>][:POWer][:AVG]:RANGe[:
VALue]
on page 350
User Defined Transition
Available if Range State is set to "Auto".
Enables or disables the reduction of the transition range between the measurement
paths, entered under
Offset .
Remote command:
CALCulate<Measurement>[:CHANnel<Channel>][:POWer][:AVG]:RANGe:
CLEVel:STATe
on page 350
Range settings