Rohde & Schwarz 1336.5401.02, User Manual, Page: 63 / 123

Operating the R&S QAR
R&S
®
QAR
63 User Manual 1178.7200.02 ─ 09
2. Normalize the measurement, as described in Chapter 5.3.3.1, "Normalization" ,
on page 66.
3. Place the bumper to measure in the right position, as described in Chapter 5.3.1,
"Test Setup" , on page 63.
4. Measure the attenuation, as described in Chapter 5.3.3.2, "Attenuation Measure-
ment" , on page 66.
5. Save the measurement results, if needed.
See also "Managing measurement results" on page 67.
5.3.1 Test Setup
► Place the bumper between the R&S QAR and the reference reflector, at a mini-
mum distance of 30 mm from the reflector pins.
5.3.2 Graphical User Interface
The graphical user interface (GUI) contains several elements.
2 1
3 4 5
8 9 7 10
6
Figure 5-17: Software user interface
1 = Menu bar
2 = Bumper type selection
3 = System messages
4 = Normalize button
5 = Result display
6 = Result display hide / unhide
Bumper Measurements