Rohde & Schwarz 1323.0012.03, User Manual

Page: 583 / 1014

Command Reference
R&S
®
ZNL/ZNLE
583 User Manual 1178.5966.02 ─ 07
● SOURce Commands .............................................................................................887
● STATus Commands .............................................................................................. 893
● SYSTem Commands .............................................................................................896
● TRACe Commands ...............................................................................................906
● TRIGger Commands .............................................................................................909
10.5.2.1 CALCulate Commands
The
CALCulate...
commands perform post-acquisition data processing. Functions
in the
SENSe
subsystem are related to data acquisition, while the
CALCulate
subsys-
tem operates on the data acquired by a
SENSe
function.
CALCulate:CLIMits...
The
CALCulate:CLIMits...
commands control the composite limit check.
CALCulate:CLIMits:FAIL?
Returns a 0 or 1 to indicate whether or not a global, composite limit check on several
traces has failed.
Since V2.20 of the R&S ZNL/ZNLE FW the result is automatically recalculated when-
ever a relevant setting is changed, i.e. a subsequent query will return the updated limit
violation state.
Example: *RST; CALC:LIM:CONT 1 GHZ, 2 GHZ
Define an upper limit line segment in the stimulus range
between 1 GHz and 2 GHz, using default response values.
CALC:LIM:STAT ON; FAIL?
Switch the limit check on and query the result.
CALC:CLIM:FAIL?
Query the result for the composite limit check. As only one trace
is tested, the response should be equal to the previous
response.
Usage: Query only
Manual operation: See "Global Check" on page 401
CALCulate:DATA...
The
CALCulate:DATA...
commands provide access to the results of a measure-
ment.
Data format
The trace data is transferred in either ASCII or block data (REAL) format, depending
on the
FORMat[:DATA]
setting. If block data format is used, it is recommended to
select EOI as a receive terminator (
SYSTem:COMMunicate:GPIB[:SELF]:
RTERminator EOI
).
VNA Command Reference
www.allice.de Allice Messtechnik GmbH