Rohde & Schwarz 1312.8000K08, Getting Started, Page: 43 / 123

Instrument Tour
R&S
®
FSW
43 Getting Started 1338.4102.02 ─ 08
ible (0 V / 5 V). You control the connector usage in the "Trigger" settings ([TRIG]
key).
The trigger output also controls signals by the frequency mask trigger available in
Real-Time mode.
The rear panel provides a third TRIGGER INPUT / OUTPUT connector, see
Chapter 5.2.12, "TRIGGER 3 INPUT/ OUTPUT" , on page 54. (Not models
1312.8000Kxx)
For R&S
FSW85 models, the second trigger (female BNC TRIGGER
INPUT / OUTPUT connector) on the front panel is not available due to the
second RF input connector (see
Chapter 5.1.7, "RF INPUT 50 Ohm" ,
on page 43).
5.1.7 RF INPUT 50 Ohm
Provides RF input from a connected device under test (DUT) to the R&S FSW,
which is then analyzed in an RF measurement. Connect the DUT to the "RF
Input" connector on the R&S
FSW. Do not overload the input. For maximum
allowed values, see the data sheet.
The specific connector type depends on the instrument model:
●
R&S FSW26 : APC 3.5 mm male (compatible with R&S SMA)
●
R&S FSW43 : 2.92 mm male (compatible with R&S SMA)
●
R&S FSW50/67 : 1.85 mm male (compatible with 2.4 mm)
●
R&S FSW85 :
– Input 1: 1.00 mm RF input connector for frequencies up to 85 GHz
(90 GHz with option R&S FSW-B90G)
– Input 2: 1.85 mm RF input connector for frequencies up to 67 GHz
For models 1312.8000Kxx:
1.00
mm RF input connector for frequencies up to 85 GHz (90 GHz with
option R&S FSW-B90G)
Front Panel View