Rohde & Schwarz 1173.8709K02, User Manual

Page: 50 / 123

Remote control commands
R&S
®
NRPxxTWG
50 User Manual 1178.8371.02 ─ 08
Parameters:
<level> Range: 300e-9 to 100.0e-3
*RST: 3.0e-5
Default unit: Watts
TRIGger:LEVel:UNIT <unit>
Sets the unit of the trigger level if this value is entered without a unit. See also
TRIGger:LEVel
on page 49.
Parameters:
<unit> DBM | W | DBUV
*RST:
W
TRIGger:SENDer:PORT <sender_port>
Selects the port where the power sensor outputs its own trigger event in case it is trig-
ger sender. See
TRIGger:SENDer:STATe
for more information.
If the power sensor is the trigger sender, it can output its trigger event either on the
EXTernal<1>
or
EXTernal2
.
If the power sensor triggers itself, the trigger source of the power sensor must be
assigned to the other external port, as shown in the examples.
Parameters:
<sender_port> EXT1 | EXTernal1 | EXT2 | EXTernal2
*RST:
EXT1
Example: TRIG:SEND:PORT EXT1
TRIG:SOUR EXT2
TRIG:SEND:STAT ON
Example: TRIG:SEND:PORT EXT2
TRIG:SOUR EXT1
TRIG:SEND:STAT ON
TRIGger:SENDer:STATe <state>
Enables or disables the trigger sender mode of the power sensor. In this state, the
power sensor can output a digital trigger signal in sync with its own trigger event.
If enabled, select the output port for the trigger signal using
TRIGger:SENDer:PORT
.
Typically, the trigger sender uses its internal trigger source. But you can also trigger the
trigger sender externally, because the power sensor has got two external trigger con-
nectors. If you trigger the trigger sender externally, use
EXTernal1
as external trigger
input port (trigger source) and
EXTernal2
as trigger sender output port or vice versa.
Parameters:
<state> *RST: OFF
Controlling the measurement