ROGERS LABS, INC.
Speedcam, Inc.
4405 W. 259th Terrace
MODEL: DT 100U
Louisburg, KS 66053
Test #: 030506
FCCID#: Q4X DT100U
Phone/Fax: (913) 837 -3214
Test to: FCC Parts 2 and 90
Page
13 of 13
Q4XDT100UUserman1.doc 5/13/2003
FCC Information
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE CONDITION THAT THIS DEVICE DOS NOT
CAUSE HARMFUL INTERFERENCE.
MODIFICATIONS OR CHANGES NOT EXPRESSLY APPROVED BY THE
MANUFACTURER COULD VOID THE USER’S AUTHORITY TO OPERATE THE
EQUIPMENT.
IMPORTANT NOTE: To maintain compliance with the FCC's RF exposure guidelines, hold the
transmitter and antenna at least 1 inch (2.5 centimeters) from your face and speak in a normal
voice, with the antenna pointed up and away from the face. If you wear, the handset on your body
while using the headset accessory, use only the manufacturers supplied belt clip for this product
and ensure that the antenna is at least 1 inch (2.5 centimeters) from your body when transmitting.
To provide the recipients of your transmission the best sound quality, hold the unit at least 5cm (2
inches) from the mouth, and place the antenna slightly off to one side.
Your radio generates radio frequency electromagnetic energy during
transmission mode. The radio is designed for and classified as
“Occupational Use Only” and must be used by individuals who are
properly trained and aware of these hazards and the means in which to
minimize such hazards. This radio is NOT intended for use by the
“General Population” or in uncontrolled environments.
To ensure that your exposure to radio frequency electromagnetic energy is
within the FCC allowable limits for occupational use, always follow these
guidelines:
DO NOT operate the radio without a proper antenna attached, as this may
damage the radio and increase your RF exposure. A proper antenna is
supplied with the radio by the manufacturer or an antenna specifically
authorized by the manufacturer for use with this radio.
DO NOT transmit for more than 50% of the total radio use time (this is a
maximum 50% duty cycle radio). Transmitting more than 50% can cause
FCC RF exposure compliance requirements to be exceeded. Pressing the
PTT switch enables the radio to transmit.
ALWAYS use ONLY authorized accessories with this radio. Use of
unauthorized accessories can cause the FCC RF Exposure compliance
requirements to be exceeded.
