16
16
EN
9
Activating a user code / transmission
Enter the previously stored user code (e.g.
34741
) followed by star (*).
If the code has been stored in the memory, the keypad’s green
LV
LED lights up.
Press and hold the enabled key/channel (e.g.
4/B - CH_B
).
Example:
34741
*
B
If ONLY ONE of the channels
CH
is enabled (
1/A
...
4/B
...
7/C
...
*/D
), radio transmission is activated immediately after the
user code is entered followed by pressing the * (asterisk) key:
EXAMPLE with user code
89512
and channel
CH_A
enabled.
89512 *
(CH_A transmit)
N.B.:
transmission continues as long as the asterisk key (*) is held; the
H85/TDR
keypad switches off as soon as the
key is released.
WARNING
!
•
A maximum of 5 s may elapse between pressing one key and the next, otherwise an error alert is activated (the red
LR
LED blinks rapidly 3 times) and the code must be entered again.
•
Pressing a key/channel that has not been enabled (
1/A
,
4/B
etc.) does not activate radio transmission.
•
In case of error while entering the code, press
#
to exit activation mode.
10
Deleting a user code (fig. 12)
Identify the user code (e.g.
34741
) to be deleted, and enter in sequence:
# #
34741
*
If the code is present in the memory, the red
LR
LED blinks and then remains steady-on.
Confirm within 5 s, by entering
34741
*
If the two codes have been entered correctly (the same), the procedure is successful and the green
LV
LED lights up for
2 s. The buzzer sounds until the LED goes out.
Using again our example with user coder to delete
34741
:
# #
34741
*
34741
*
11
Changing password
(fig. 8)
For the security of the installation, it is recommended to change the password from the factory default value 0000.
The “change password” operation also selects the type of encoding of the radio transmission: fixed code or “rolling
code”.
Therefore, if you only wish to change the type of encoding without changing the password, you must carry out the
sequence described, taking care to keep the password.
The factory default password is
0000
.
Change password from 0000 to 12345, tx radio fixed code, enter in sequence:
* *
0000
*
(the red
LR
LED lights up)
12345
*
12345
*
Change password from 0000 to 12345, tx radio rolling code, enter in sequence:
* *
0000
#
(the red
LR
LED lights up)
12345
#
12345
#
If the procedure is successful, the green
LV
LED lights up and the buzzer sounds for 2 s.
If the procedure is NOT successful, the red
LR
LED blinks rapidly 5 times and the buzzer sounds intermittently.
11.1
Reset password to factory setting (fig. 9)
If the password is lost/forgotten, it can be reset to the factory default value (
0000
) by knowing any of the user codes
stored in the H85/TDR.
To reset the password, if for example the user code
12345
, is known, enter in sequence:
