19
RODIA
®
350 RS SERIES
GB
Diamond blade dressing
Diamond blades performs best when they
are dressed .
After time and use, diamonds on the outer
edge of the blade might become glazed
or dull . This will reduce cutting efficiency
and possibly cause the blade to bend .
As a result the cut will not be straight and
mis-aligned . When this occurs, the blade
needs to be dressed .
The diamond blade can be dressed with a
dressing stick .
Dressing procedure(s):
• Place a dressing stick on the saw table
• Make approx . 10 cuts through the
dressing stick .
The diamond blade should be sharp again
and ready for further efficient cutting .
ENVIRONMENTAL
PROTECTION
Do not dispose of the appliance
with domestic waste . Dispose of
the appliance only via an
authorized waste management
company or your municipal
waste management organisation . Adhere
also to the applicable regulations . In case
of doubt refer to your waste management
organisation . Recycle all packaging
material in an environmentally friendly
manner .
TROUBLESHOOTING
Problem
Cause
Solution
The machine
doesn’t start .
The power supply cable is
damaged or not properly
connected .
No voltage in the power outlet .
Start switch is damaged .
Press the plug firmly in the power
outlet . Check the power supply
cable .
Have the power outlet checked .
Have the switch replaced .
Water doesn’t flow
at the blade but the
pump is running .
The sprayers are clogged .
The water level in the water bin
is not sufficient . The pump is not
totally submerged .
Water valve is closed .
Clean the sprayers .
Fill the water bin with clean
water until the pump is totally
submerged .
Open the valve .
Motor isn’t running
smoothly .
Water may have seeped
through inside the motor .
Capacitor is damaged .
Damaged motor bearing .
Unplug the power cable and
consult your local dealer .
Pump isn’t running . The impeller or suction filter of
the pump is damaged .
No proper connection of the
power cable .
Replace damaged parts .
Have the connection checked .
