22
2.3 MODEL RN-4110
1. RCA line outputs
(CH L + CH R; left and right channels).
Line outputs to pass-thru the input signal to another amp
2. Input gain control
. LEVEL adjustment for channels CH3
+ CH4. Used to match the RCA line output voltage of the
head unit to the amplifier input section
3. Bass EQ control
. Bass emphasis adjustment for CH3 +
CH4 with a center frequency of 45 Hz from 0 dB to 10 dB
4. Lowpass crossover frequency control
, to adjust the
cut-off frequency of the channels CH3 + CH4
5. X-Over operation mode slide switch
. Used to select
high pass, band pass or full range operation of the active
crossover for channels CH3 + CH4
6. High pass crossover frequency control
, to adjust the
subsonic cut-in frequency of the channels CH3 + CH4
7. Remote port
. To connect the cable of the bass level
remote control to the amplifier, driving CH3 + CH4
8. RCA line inputs
(CH3 + CH4; left and right channels).
Line inputs for connection of the amp with RCA line-outs
of the head unit
9. RCA line inputs
(CH1 + CH2; left and right channels).
Line inputs for connection of the amp with RCA line-outs
of the head unit
10. Molded terminal
for the connection of two speaker
wires for CH1 & CH2 and CH3 + CH4 to the amp
11. Maxi fuse
to protect the power supply of the amplifier
from damage
12. “+12V”
for connection to the positive terminal of car
battery
13. “REM”
for the automatic (remote) turn-on / turn-off of
the power amplifier from the head unit's amplifier remote
wire
14. “GND”
for connection to chassis ground or negative
terminal of car battery
15. Input gain control
. LEVEL adjustment for channels CH1
+ CH2. Used to match the RCA line output voltage of the
head unit to the amplifier input section
16. Bass EQ control
. Bass emphasis adjustment for CH1 +
CH2 with a center frequency of 45 Hz from 0 dB to 10 dB
17. Low pass crossover frequency control
, to adjust the
cut-off frequency of the channels CH1 + CH2
18. X-Over operation mode slide switch
. Used to select
high pass, band pass or full range operation of the active
crossover for channels CH1 + CH2
19. High pass crossover frequency control
, to adjust the
subsonic cut-in frequency of the channels CH1 + CH2
20. RCA input operation mode slide switch
. Used to
select 2CH input driving all four channels of the amp, or
4CH input to drive all four channels of the amp
2. INPUTS – OUTPUTS – CONTROLS
NC-Amp 1-2-4-5-CH ME_pfade.indd 22
09.05.2009 11:25:33 Uhr
