Roda DA05+, User Manual, Page: 5 / 49

DA05+ WM6 User Manual roda
—————————————————————————————
—————————————————————————————
Page 5 of 49
EMC and Safety Notice
Federal Communications Commission Radio Frequency Interference Statement
This equipment has been tested and found to comply with the limits for a class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and radiates radio frequency energy and if not installed
and used in accordance with the instructions, may cause interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
-
Re-orient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the supplier or an experienced radio/TV technician for help.
This Transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Any changes or modifications (including the antennas) made to this device that are not
expressly approved by the manufacturer may void the user
’ s authority to operate the
equipment.
This equipment complies with FCC RF radiation exposure limits set forth for an un-
controlled environment. To maintain compliance with FCC RF exposure compliance
requirements, avoid direct contact to the transmitting antenna during transmitting.
Countermeasures if interference occurs
You are encouraged to do the following if interference occurs while you are operating the
device:
Turn OFF the unit and unplug the AC adapter from the outlet to see if the interference
disappears.
Connect the AC adapter to the outlet in another room and check if the interference still
exists.
Use an outlet that is far away from the interfered appliance.
Re-orient your computer in respect to the interfered appliance to see if there is
improvement.
If all of these failed, please call your supplier for help.
CE
This equipment complies with the requirements set out in the Council Direction on the
Approximation of the laws of the Member States relating to Electromagnetic Compatibility
(89/336/EEC). For the evaluation regarding the electromagnetic compatibility, the
following standards were applied:
Standards Specifications and Parameters
EN 301 489-17 1.2.1 ERM EA2: 2003 Class B EMI Conduction and