3
7.
Slim, light, and handy.
8.
USB Bus powered (4.5V ~ 5.5V)
9.
LED indicator light up when Commander is
recognized by PC
3. Technical Specifications
1. Dimension: 75mm X 24mm X 12mm (L X W X H)
2. Weight: 28g
3. Erase cycle: 1,000,000 times
4. Data retention time: 10 years
5. Read transfer: Up to 900KB/second
6. Write transfer: Up to 900KB/second
7. Shock resistance: Up to 100G
8. Operating Temperature 0-60 degree Celsius
* Design and specifications of Commander are subject to
change without prior notice and may not be reflected in
this manual.
4. Fingerprint Sensor Mode of Operations:
For clarity, please refer to “QUICK INSTAL” page.
1.
Factory Settings-Empty fingerprint template. The
fingerprint template is empty as it was deleted in the
factory. Internal flash memory is preformatted. When
user plugs the Commander into the USB port, the
ORANGE led will light up and the RED led will blink
slowly awaiting for fingerprint enrollment.
2.
Entry of fingerprint template – Enrollment Mode
3.
It’s important that the fingerprint is entered properly.
Place the fingerprint according to fingerprint Guard
with the center of fingerprint directly on the center of
fingerprint sensor. After authentication, it is always a
good practice to remove the finger by sliding away
4
from sensor to clear the fingerprint on the sensor.
This is illustrated in “Pg 10” of this user manual.
4.
Normal Use of Commander – Authentication Mode
5.
Please make sure the Enrollment Switch is in Normal
Setting. Upon authentication of authorized
fingerprint, the Green led will be ON for short time
and then enter USB Mass Storage Mode.
6.
Re-Enrollment of Fingerprint Template
7.
Commander allows the change of user fingerprint
template by first deletion of the fingerprint template.
That is Enrollment Switch is set to Enrollment setting
before plugging Commander into USB port. Upon
plugging in, the RED led will be blinking and wait for
authorized fingerprint. Once authenticated, the
fingerprint template will be deleted and Orange led
will light up. In case Commander is unplugged at this
moment (which we do not encourage), the fingerprint
template will be emptied. The fingerprints can be
entered during the next plug-in. However, we
encourage users to enter new set of fingerprint
immediately.
8.
Deletion of Fingerprint Template Fingerprint
template can be deleted easily but we do not
encourage the user to do so. A Commander with
empty fingerprint template is open to theft. If the
fingerprint template is deleted, the data stored in
Commander is still retained as it is.
5. USB Mass Storage Driver Installations:
1.
WIN98/ WIN98 SE Installation
2.
Do not plug in the Commander driver before
installation
3.
Please download the Window® drivers at
www.Microsoft.com