More information about the sound decoder can be found here
GB
Starting locomotive operation
GB
Maintenance of the model
Unwrap model:
Take out the model cautiously
with foil (fig. 1).
Operating instructions:
Before use is advisab-
le to let the loco go around about 30 minutes for-
wards an 30 minutes backwards without load, to
obtain an optomal circuit and best tractive power.
Your locomotive will run smoothly on clean tracks
only. For this purpose we recommend using item
no.
10002, ROCO track cleaning rubber
, for
removing heavy dirt.
Fittings:
In the enclosed accessory bag you will
find small kits to be fitted on your locomotive.
Please
mount them cautiously.
Attention!
Use glue only if indicated (fig. 2).
Running in digital mode:
Remove the jumper from the interface.
Finally put the plug of the chip into the interface
as shown in fig. 5.
To enjoy your model for a long time, it is neces-
ary to
service
it regulary (i.e. after it has been in
ope-ration for approximately 30 hours).
1. Cleaning of wheel contacts:
Wheel cont-
acts easily get dirty on tracks which are not enti-
rely clean. Use a small brush to
remove dirt
from
spots marked in fig. 8.
2. Lubrication:
Apply
tiny oil drops
to spots
marked in fig. 7. Prior to lubrication dismantle lo
-
comotive (fig. 3). We recommend using item no.
10906, ROCO oiler
. For lubrication the gearparts
(e.g. cogwheels, worm) we whould recommended
our ROCO
special grease
(item no.
10905
).
Attention:
Please do not oil these parts when
using our grease.
3. Change of traction tyre:
Remove the gear
cover (fig. 4). Take out
wheel set
and remove
traction tyre
using a pin or a fine screwdriver
(fig. 6). When pressing on the new traction tyre
please
avoid twisting it
.
4. Motor Changing:
First remove loco body (fig.
3), and then the motor (fig. 9).
Assembly:
During assembly please take care of
correct position of contacts.
10
3
