More information about the sound decoder can be found here
Decoder interface
1
3
5
7
9
11
13
15
17
19
21
2
4
6
8
10
12
14
16
18
20
22
P
lux
16
GB
Starting locomotive operation
Maintenance of the model
Aux. 6
Aux. 7
GPIO/C
Zugbus-Clock / GPIO/B
Masse GND
Front light, Drivers cab 1
V (+)
Twist protection
Front light, Drivers cab 2
Speaker A
Speaker B
Aux. 4
Aux. 3
GPIO/A / Zugbus-Data
DC (+) Elko
Engine right (+)
Engine left (-)
Track/Pick up right
Track/Pick up left
Aux. 1 red Taillight, Drivers cab 2
Aux. 2 red Taillight, Drivers cab 1
Aux. 5
Unwrap model:
Take out the model cautiously
with foil (fig. 1).
Operating instructions:
Before use is advisab-
le to let the loco go around about 30 minutes for-
wards an 30 minutes backwards without load, to
obtain an optomal circuit and best tractive power.
The smallest radius this model should run is
R2
of
the ROCO track system (R2 = 358 mm).
Your locomotive will run smoothly on clean tracks
only. For this purpose we recommend using item
no.
46400, Roco track cleaning van
, or item
no.
10002, Roco track cleaning rubber
, for
remo-ving heavy dirt.
Fittings:
Operation is possible with different
couplings (fig. 2). We recommend using the Roco
close coupling.In the enclosed accessory bag you
will find small kits to be fitted on your locomotive.
Please
mount them cautiously.
Attention!
Use glue only if indicated (fig. 2).
Running in digital mode:
Remove the jumper from the interface.
Finally put the plug of the chip into the interface
as shown in fig. 5.
Installation of function decoders in the
traction cars without motor:
Remove the
jumper from the interface.
Finally put the plug of the chip into the interface
as shown in fig. 8.
To enjoy your model for a long time, it is neces-
ary to
service
it regulary (i.e. after it has been in
ope-ration for approximately 30 hours).
1. Cleaning of wheel contacts:
Wheel cont-
acts easily get dirty on tracks which are not enti-
rely clean. Use a small brush to
remove dirt
from
spots marked in fig. 6.
2. Lubrication:
Apply
tiny oil drops
to spots
marked in fig. 7. Prior to lubrication dismantle lo
-
comotive (fig. 3). We recommend using item no.
10906, Roco oiler
. For lubrication the gearparts
(e.g. cogwheels, worm) we whould recommended
our Roco
special grease
(item no.
10905
).
Attention:
Please do not oil these parts when
using our grease.
3. Motor Changing:
First remove loco body and
interior (fig. 3+9), and then the motor (fig. 9).
Assembly:
During assembly please take care of
correct position of contacts.
10
3
Motor car 70378
