background image

4

 

Eastwood Technical Assistance: 800.343.9353  >>  [email protected]

SET-UP 

•  Using a good quality Teflon sealing tape (not included), thread the 1/4” MNPT, Male quick 

disconnect inlet fitting into the air inlet.

INJURY HAZARD! 

  To avoid injury, always disconnect air supply to Die Grinder before installing  

or replacing accessories.

INJURY HAZARD! 

  To avoid injury, only use accessories rated for High-RPM,  

(22,000 or greater) use.

TO INSTALL OR SWITCH ACCESSORIES (not included)

•  With air supply disconnected, 

Slide the smaller 14mm end of a 
Collet Wrench over the flats of the 
shaft and the larger 19mm end of 
a Collet Wrench over the flats of 
the Collet Retainer 

(FIG 1)

.  

Loosen the threaded-on Collet 
Retainer to release the Collet grip 
on accessory then and pull out 
the accessory. Replace accessory 
with one of the same size shank 
by sliding the shank into the  
Collet then retighten securely.

TO SWITCH TO A COLLET OF ANOTHER SIZE

•  With air supply disconnected, 

Slide the smaller 14mm end of a 
Collet Wrench over the flats of the 
shaft and the larger 19mm end of 
a Collet Wrench over the flats of 
the Collet Retainer. Loosen then 
remove the threaded-on Collet 
Retainer and place it aside for 
re-installation 

(FIG 2)

.

•  Withdraw the accessory  

(if installed) and the Collet.

•  Install Collet into bore of Shaft.
•  Place accessory (not included) into Collet.
•  Replace Collet Retainer and tighten securely with included Wrenches.

1/8” Collet

FIG. 1

FIG. 2

1/4” Collet

Collet 

Retainer

Reviews: