Rockwood 31741 Instructions Manual Download Page 3

To order parts and supplies: 800.343.9353  >>  eastwood.com 

3

 

 READ INSTRUCTIONS 

•  Thoroughly read and understand these product instructions before using 

this tool. Failure to follow all warnings can result in tool damage or serious 
physical injury.

•  Keep these product instructions for future reference.

 

•  Dust and fine particles are generated while cutting which can contain  

hazardous or toxic substances. Breathing this dust can cause many  
serious respiratory health conditions. Always use NIOSH approved  
respiratory protection while using this tool.

 

EYE INJURY HAZARD!

•  Rapidly rotating surfaces can eject metal particles, dirt and oils at high ve-

locity. Always wear ANSI approved eye protection when operating this tool.

 

HEARING DAMAGE HAZARD!

•  The Rockwood Pneumatic Cut-Off Tool emits high sound levels while  

operating. Use ANSI approved ear protection when operating this tool.

 

DANGER indicates a hazardous situation which, if not avoided, will result in death or serious injury.

 

WARNING indicates a hazardous situation which, if not avoided, could result in death or serious injury.

 

CAUTION used with the safety alert symbol, indicates a hazardous situation which, if not avoided, 
could result in minor or moderate injury.

 

NOTICE is used to address practices not related to personal injury.

SAFETY INFORMATION

The following explanations are displayed in this manual, on the labeling, and on all other information 
provided with this product:

Summary of Contents for 31741









Reviews: