9
SoniCrafter
®
ENG
TECHNICAL DATA
Model
RK5105K
RK5106K/RK5107K
RK5108K
Rated voltage
120V~60Hz
Amps
2.3A
Oscillations
speed
20000rpm
11000-20000rpm
Oscillations
angle
3.2°
Protection
class
/II
Machine
weight
2.8Lbs
OPERATING INSTRUCTIONS
NOTE:
Before using the tool, read the instruction
book carefully.
1. MOUNTING ACCESSORIES (See A1
,
A2)
CAUTION:
For all work or when changing
application tools, always wear protective gloves.
Avoid danger of injury from the sharp edges of the
application tools. Application tools can become very
hot while working, presenting danger of burns!
wARNING:
To reduce the risk of injury, do not
let the cut blades or any saw blades face back
toward the user’s hand.
Unscrew the bolt (5) and remove the flange (6).
Clean the tool holder, the application tool and the bolt
(5) and flange (6).
Place the application tool exactly onto the hex-shaped
tool holder. Note that the application tool has a flush fit.
Reposition the flange and tighten the bolt (5) using the
supplied Allen key.
2. ADAPTER(23)
Accessories of other brands( Fein
®
, Bosch
®
, and
Dremel
®
) can be fitted onto the SoniCrafter
®
brand tool
using the adapter.
NOTE:
Fein is a registered trademark of C. & E. Fein
GmbH. Bosch is a registered trademark of Robert
Bosch GmbH. Dremel is a registered trademark of
Credo Technology Corporation.
3. MOUNTING / CHANGING THE SANDING SHEET (SEE
B1,B2)
Align the sanding sheet and press it onto the sanding
pad by hand.
Align the holes of the perforated sanding sheets with
the holes of the perforated sanding pads when used.
(see B2)
Firmly press the power tool with the sanding sheet
against a flat surface and briefly switch the power tool
on. This provides for good adhesion and prevents
premature wear.
If one point has become worn, pull off the sanding
sheet, turn it 120° and replace.
4. MOUNTING THE SUCTION DEVICE(SEE C,D)
wARNING: bEFORE MOUNTING OR REPLACING
APPLICATION TOOLS OR ACCESSORIES, PULL THE
POwER PLUG.
This preventative safety measure eliminates danger
from accidentally starting the power tool. Mount the
suction device as shown in
C1-D2.(RK5107K/RK5108K)
5. OPERATING THE ON/OFF SwITCH
- Switching the power tool ON:
Slide switch (1) forward (
I
).
- Switching the power tool OFF:
Slide switch (1) backward (
0
).
6. USING THE VARIAbLE SPEED CONTROL (RK5106K/
RK5107K/RK5108K)
Select oscillation frequency (speed) while the motor is
running.
The variable speed control (2) can be used to set
the optimum oscillating frequency according to the
accessories used and the respective application.
High oscillation frequency:
Sanding, sawing, rasping and polishing stone and
metal.
Low oscillation frequency:
Polishing varnishes.
7. SECURING THE wORKPIECE
CAUTION:
Before working with your tool make
sure that no power cords will be damaged.
8. SANDING
Typical application: wood, metal; small areas, especially
corners, edges and places difficult to access.
Select high oscillation frequency (for variable speed
models).