Rockwell RG8356.9, Manual

Page: 14 / 20

14
18V POLE CHAIN SAW EN
Negative terminal
Double insulation (for charger)
RCM marking
TECHNICAL DATA
Rated Voltage 18V
Bar length: 20 cm
Chain speed 3.8 m/s
Oil tank capacity 80 ml
Chain pitch 9.5 mm
Charger model RW9897
Charger input 100-240V ~ 50/60Hz, 70W
Charger output 20V , 2.5A
Charger protection
class
/II
Battery type Li-Ion
Battery model RW9894/RW9906
Charging time
(approx.)
2.0 Ah
(RW9894)
55 min
4.0 Ah
(RW9906)
105 min
Weight( chain & bar
included)
2.78 kg
NOTE:
• The accessories of battery charger (RW9897)
and battery pack (RW9894 / RW9906) illustrated or
described are not included in RG8356.9 delivery.
• Charging time may change a little bit due to various
charging situations.
ASSEMBLY
WARNING! Do not insert the battery pack
to the machine before it is completely
assembled.
Always use gloves when handling the chain.
TO ASSEMBLE THE POLE (SEE FIG. A1-A6)
1. Loosen the clamping knob (9) by turning it anti-
clockwise. Extend the pole to expose the two small
cylinders (a). Turn the clamping knob (9) clockwise to
lock the pole to avoid pole movement while assembling.
2. Align and insert the extended pole into the machine
head.
NOTE:
• The two cylinders (a) on the pole should be inserted
exactly into the two small holes (b) of the machine head.
(See Fig. A1, A4)
• The bulge (c) at the end of the pole should be exactly
inserted into the hole (d) inside the machine head. (See
Fig. A2, A3)
3. Tighten the sleeve (e) securely by turning clockwise.
NOTE: Make sure that the sleeve is firmly tightened in
place. (See Fig. A6)
WARNING!
• Before assembling the extension pole to the
machine, make sure that the tool is switched off and
the battery pack has been removed.
• When using this machine with the Extension
Pole, make sure to first insert the battery pack.
• ELECTROCUTION HAZARD:
Never use the Saw or Extension Pole in an area with
overhead power lines or where the branch being cut
can come into contact with overhead power lines.
ADJUSTING POLE LENGTH
The pole saw has a telescoping pole assembly that
will extend from 90cm (fully retracted) to 140cm (fully
extended).
A clamping knob (9) is used to hold the pole in position
at any extended length.
1. To extend the pole, firstly loosen the knob and
then pull inner pole section out to desired length of
extension as shown in Fig.B1. Pole will slide freely.
Note: Only extend pole to minimum length required to
reach limb that is being cut.
2. To lock pole in position, tighten the knob clockwise
as shown in Fig.B2.
ABN: Australian Business Number. By this number,
business information such as entity type, status,
business location etc. can be found at website
http://abr.business.gov.au.
ABN of Positec Australia Pty Limited is 14 101 682 357