9
2200W ANGLE GRINDER
EN
Double insulation
RCM marking
TECHNICAL DATA
Voltage
230-240V~50Hz
Power input
2200W
Input current
10A
Rated no load speed
6600/min
Disc size
230mm
Dissc bore
22.2mm
Spindle size
M14
Protection class
/II
Machine weight
4.32kg
OPERATING INSTRUCTIONS
NOTE:
Before using the tool, read the instruction
book carefully.
INTENDED USE
The machine is intended for cutting, roughing and
brushing metal and stone materials without using
water. For cutting metal, a special protection guard for
cutting (accessory) must be used.
1. FITTING THE SAFETY GUARD (See Fig. A1, A2)
WARNING!
Always ensure that the tool is
switched off and that the power supply cord is
disconnected from mains power supply before fitting
accessories or making any adjustments.
WARNING!
Do not operate this tool without the
safety guard being correctly attached. Always
check before operation. Failure to do so could result
in serious personal injury.
Wheel Guard for Grinding
The coded projection on the wheel guard (8) ensures
that only a guard that fits the machine type can be
mounted.
Loosen the Clamp Adjusting Nut (15).
Place the wheel guard (8) with coded projection into
the coded groove on the spindle of the machine head
and rotate to the required position (working position).
The closed side of the wheel guard (8) must always
point to the operator.
Then tighten the Clamp Adjusting lever (A2).
Wheel Guard for Cutting
WARNING!
For cutting metal, always work with
the wheel guard for cutting.
The wheel guard for cutting (13) is mounted in the
same manner as the wheel guard for grinding.
Open the clamping lever. Place the wheel guard (8)
with coded projection into the coded groove on the
spindle of the machine head and rotate to the required
position (working position).
To fasten the wheel guard (8), close the clamping
lever.
The closed side of the wheel guard must always point
to the operator.
NOTE:
with the clamping lever open the clamp
adjusting nut can be adjusted to ensure the guard is
securely clamped after the clamping lever is finally
closed.
2. INSTALLING AND ADJUSTING AUXILIARY HANDLE (See
Fig. B)
An auxiliary handle is supplied and can be fixed into
any of the three positions on the gear housing. If you
are right handed fit the handle as shown in Fig B. If
you are left handed fit the handle the other way round.
When using a cutting disc, you can screw the handle
into the position on top of the gearcase.
NOTE:
This handle should be used at all times to
maintain complete control of the tool.
3. FITTING THE DISCS (See Fig. C1, C2, C3)
Put the inner flange onto the tool spindle. Ensure it is
located on the two flats of spindle (See Fig C1).
Place the disc on the tool spindle and inner flange.
Ensure it is correctly located. Fit the threaded outer
flange making sure it is facing in the correct direction
for the type of disc fitted. For grinding discs, the
flange is fitted with the raised portion facing towards
the disc. For cutting discs, the flange is fitted with the
ABN: Australian Business Number. By this number,
business information such as entity type, status,
business location etc. can be found at website
http://abr.business.gov.au.
ABN of Positec Australia Pty Ltd is 14 101 682 357
