Chapter
2
Programming and Parameters
Chapter 2 provides a complete listing and description of the PowerFlex
700H parameters. The parameters can be programmed (viewed/edited)
using an LCD HIM (Human Interface Module). As an alternative,
programming can also be performed using DriveExplorer™ or
DriveExecutive™ software and a personal computer. Refer to
for a brief description of the LCD HIM.
About Parameters
To configure a drive to operate in a specific way, drive parameters may have
to be set. Three types of parameters exist:
•
ENUM Parameters
ENUM parameters allow a selection from a list of items. The LCD HIM
will display a text message for each item.
•
Bit Parameters
Bit parameters have individual bits associated with features or
conditions. If the bit is 0, the feature is off or the condition is false. If the
bit is 1, the feature is on or the condition is true.
•
Numeric Parameters
These parameters have a single numerical value (i.e. 0.1 Volts).
The example on the following page shows how each parameter type is
presented in this manual.
For information on . . .
See page . . .
Parameter Cross Reference – by Name
