Rockwell ArmorStratix 5700 series, Instructions Manual

Page: 427 / 548

Rockwell Automation Publication 1783-UM007F-EN-P - September 2016 427
Troubleshoot the Switch Chapter 9
Reset a Stratix 8000/8300 Switch
1. Remove power from the switch.
2. Reapply power to the switch.
3. While the switch is powering up, press and hold the Express Setup
button.
4. When the EIP Mod, EIP Net and Setup status indictors turn red, release
the Express Setup button.
Troubleshoot a
Firmware Update If you attempted to update the switch firmware but received a message that the
update failed, make sure that you still have access to the switch. If you still have
switch access, follow these steps.
1. Make sure that you downloaded the correct .tar file from
http://www.rockwellautomation.com .
2. If you downloaded the correct .tar file, refresh the browser session for
Device Manager to verify connectivity between the switch and your
computer or network drive.
• If you have connectivity to the switch and Device Manager, retry the
update.
• If you do not have connectivity to the switch and Device Manager,
refer to Recover the Switch Firmware on page 426 .