.
Operating the dispenser
1.
Insert
2
“C” cell alkaline batteries (not included).
2.
Press the female end of the green actuator adapter onto the top of the cartridge. Six
actuators are included in each case of cartridges.
3.
Slide the cartridge into the dispenser while pressing both the cartridge and green
adapter securely into place. You should hear a “beep” once the cartridge is securely in
place.
4.
Press the
RED POWER
button. The display will appear in the LCD screen.
5.
Press the
BLACK ENTER
button to cycle the dispenser until you see liquid exit
the bottom of the dispenser, just below the nut (you may have to press the enter
button up to 15 times).
6.
Press the
GREEN QUICK
button until the LCD displays
30
, indicating the
dispenser is set for a
30
day cycle. This will cycle the unit approximately every
14 minutes.
7. Close the cover to lock the dispenser unit.
8.
WARNING:
If an alarm sounds check to make sure the green actuator adapter is
firmly in place, batteries are placed properly and the cartridge is securely in place.
Monthly Service – Changing the Cartridge
1.
Replace the cartridge monthly by removing the old cartridge (with the green adapter
attached) and place the existing (or new) green adapter onto the new cartridge.
Follow the instructions above in “Operating the dispenser” section
E3-E7
.
2.
Check the drip tube to ensure it has not come loose and is still secure at the
injection point.
3.
Check the drip tube to ensure there are no blockages. If necessary replace the drip
tube.
4.
Replace batteries twice a year or as needed. Each time batteries are replaced the
GREEN QUICK
button must be pressed until the LCD displays
30
to reset the
timer.
E6
Quick Button
(Programming Options)
E5
Enter Button
(Quick Cycles)
E4
Power Button
(Turns unit on and off)
Placement considerations:
• To avoid water damage and possible malfunction, the
Power Dose
units should be installed
outside splash zones.
•
In order for the
Power
Dose
unit to achieve optimal results, it should be installed in drain lines
with daily water flow.
•
DO NOT treat dishwasher drain lines for
8-10
ft from the dishwasher. Most are
140°
or higher and will liquify grease and keep the drain line clear.
•
If there is a FOUL ODOR coming from the grease trap – Place an InVade Bio Bullet
into the trap. If the trap cannot be opened, do an initial treatment of the drain with
InVade Bio Foam, InVade Bio Drain or InVade Hot Spot.
D6
D
E2
Closed Drain Installation
E3
2
