Rockwell Automation Allen-Bradley MobileView 2711T-VMBRACKET, User Manual

Page: 46 / 104

46 Rockwell Automation Publication 2711T-UM001E-EN-P - March 2019
Chapter 4 Install and Operate the Junction Boxes
Configure the 2711T-JBIP65DC1 Junction Box
The 2711T-JBIP65DC1 junction box can be configured to work with second
generation MobileView terminals with Box ID functionality and illuminated
E-stop buttons.
Figure 10 - IP65 Junction Box Configurable Components
DIP Switch
If a MobileView terminal does not have Box ID functionality, then use this DIP
switch to configure whether or not an illuminated E-stop button is used on the
MobileView terminal.
Item
PCB
Description Description
1 B4 A DIP switch for MobileView terminals without Box ID functionality. Activate this DIP
switch if the MobileView terminal has an illuminated E-stop button. For more details, see
DIP Switch on page 46 .
2 BOX ID Two hexadecimal rotary switches for MobileView terminals with Box ID functionality. Use
these switches to set an identification (ID) number on an IP65 junction box. For more
details, see
Box ID Functionality on page 47 .
3 ADJUST Use this switch to set the brightness of the illuminated E-stop button on a second
generation MobileView terminal. For more details, see
Illuminated E-stop Button
Brightness on page 47 .
If Then
The MobileView terminal to be used has no Box ID
functionality and no illuminated E-stop button (such as
MobileView terminals with gray push buttons, cat. nos.
2711T-F10G1N1 and 2711T-T10G1N1) All DIP switches must be
deactivated (factory set as
standard)
The MobileView terminal to be used has no Box ID
functionality but has an illuminated E-stop button Activate DIP switch 8
IMPORTANT If the MobileView terminal being used has Box ID functionality and an
illuminated E-stop button, then no action is needed. The IP65 junction box
automatically detects the illuminated E-stop button, and all factory set DIP
switch settings remain deactivated.
1
2
3