Rockwell Automation Allen-Bradley LiquiFlo 2.0, User Manual

Page: 75 / 268

Rockwell Automation Publication D2-3518-4 - January 2020 75
Parameter Descriptions Chapter 9
Figure 31 - Appl Digital Output (30) Frame 4
In addition to controlling digital output 3, bit 1 is also used to force the Aux Run
digital output condition to true. This only occurs if the Digital Out Sel
parameter for one of the user-configurable digital outputs is set to
Aux Run .
The value entered into this parameter is output on the analog output when it is
configured for
Application control. See parameter Analog Out1 Sel (342).
The usable range and default for this parameter depends on the operational mode
of the analog output, which in turn depends both on the capabilities of the analog
output hardware and the current value of parameter Analog Out Config (340).
Table 6 describes the details for usable range and default.
Table 6 - Appl Analog Output (31) usable range and default
The value in the
Default
column of Table 6 is in effect when the drive powers up.
This parameter value is not stored in non-volatile memory.
For frame 3 drives (firmware version 1.x), the user-configurable analog output
hardware is located on the optional Standard I/O Board. This parameter is not
usable if the optional Standard I/O Board is not present. See
Standard I/O Board
Description (Frame 3 Only) on page 27 for terminal block assignments.
31 Appl Analog Out
Range: -32.767...32.767 [0.001 mA, or 0.001V (frame 4 only)]
Default: See Table 6 below.
Access: 1 Path: Monitor > Application
See also: 342, 343, 344
Mode Usable Range Default
0...10V (unipolar) 0.000...10.000V 0.000V
-10...10V (bipolar) -10.000...10.000V 0.000V
4...20 mA 0.000...20.000 mA 0.000 mA
0 0 0 0 0 x x x x x
0 0 1 1 2 3 4 5 6 7 8 9 11 12 13 14 15
1 =Active
0=Inactive
x =Reserved
Bit #
Shunt tr
ip
Comb. I/O Dig. Output 3 Comb. I/O Dig. Output 4 Comb. I/O Dig. Output 5 Comb. I/O Dig. Output 6 Comb. I/O Dig. Output 7 Comb. I/O Dig. Output 8
Nibble 1 Nibble 2 Nibble 3 Nibble 4
0
0 x x
Close Pre-charge
Enab
le Rectifier
0 0
Powerup Default Bit Values