Rockwell Automation Publication LDAT-UM001A-EN-P - April 2016
27
Installation
Chapter 2
Install with Foot Mount Accessory
Follow these steps to mount the linear thruster on your application with the
foot mount accessory.
1. Verify the mounting surface flatness.
The mounting surface must be flat or shimmed flat to the mounting
surface of the linear thruster within 0.127 mm (0.005 in.) to avoid
distortion and damage to the actuator housing.
2. Loosely install the all foot mounts on to your application with your
fasteners.
3. Loosely install linear thruster to foot mounts by using two of the
supplied screws per foot mount.
4. Tighten fasteners to your application.
5. Torque the foot mount screw to linear thruster to the following values.
Direct Mount the Linear Thruster
Follow these steps to mount the linear thruster on directly on your machine.
1. Verify the mounting surface flatness.
The mounting surface must be flat or shimmed flat to the mounting
surface of the linear thruster within 0.127 mm (0.005 in.) to avoid
distortion and damage to the actuator housing.
2. Install and evenly tighten the steel fasteners so the linear thruster.
Torque the steel fasteners evenly to following values.
Cat. No.
Foot Mount
Torque, max
(1)
(1)
Unless otherwise noted, torque specifications have a ±20% tolerance.
LDAT-S03
LDAT-MID-FTMOUNT
4.5 N•m (3.33 lb•in)
LDAT-S05
LDAT-S07
LDAT-S10
LDAT-LARGE-FTMOUNT
6.8 N•m (5.00 lb•in)
LDAT-S15
Cat. No.
Torque, max
LDAT-S03
4.5 N•m
(3.33 lb•in)
LDAT-S05
LDAT-S07
LDAT-S10
6.8 N•m
(5.00 lb•in)
LDAT-S15
