Rockwell Automation Allen-Bradley Kinetix 2000, Migration Manual

Page: 73 / 76

Rockwell Automation Publication 2093-AP001A-EN-P - May 2014
73
Communication Configurations Appendix E
Kinetix 5500 Servo Drive
Ring Topology
In this example, the devices are connected by using ring topology. If only one
device in the ring is disconnected, the rest of the devices continue to
communicate. For ring topology to work correctly, a device level ring (DLR)
supervisor is required (for example, the Bulletin 1783 ETAP device). DLR is an
ODVA standard. For more information, see the EtherNet/IP Embedded Switch
Technology Application Guide, publication
ENET-AP005 .
Devices without dual ports require a DLR supervisor, for example the
1783-ETAP module, to complete the network ring.
Figure 16 - Kinetix 5500 Servo Drive Ring Communication Installation
1 (Front)
2 (Rear)
00:00:BC:2E:69:F6
0 2 0
1734-AENTR
Module
Status
Network
Activity
Network
Status
Point Bus
Status
System
Power
Field
Power
POINT I O
Link 1
Activity/
Status
Link 2
Activity/
Status
CompactLogix Controller Programming Network
1783-ETAP
Module
1585J-M8CBJM-OM3
0.3 m (1.0 ft) Ethernet cable
for drive-to-drive connections.
PanelView Plus
Display Terminal
Kinetix 5500 Servo Drive System
CompactLogix 5370 Controller Logix Designer
Application
1585J-M8CBJM- x Ethernet
(shielded) Cable
1734-AENTR POINT I/O
EtherNet/IP Adapter