Rockwell Automation Allen-Bradley CENTERLINE 600, User Manual

Page: 13 / 110

Rockwell Automation Publication 1512A-UM101B-EN-P - December 2021 13
Chapter
2
Installation – Standard Enclosure
Door Opening Procedure
Opening the Low Voltage Doors
Low voltage doors are identified as LV in Figure 3 .
1. To access the low voltage compartment, use a screwdriver and turn both
of the 1/4-turn fasteners, which are located on the low voltage door, 90° in
a counterclockwise direction.
2. The door is now released and will swing open.
3. Reverse the procedure to secure the doors.
Figure 3 - Standard Cabinet
Refer to Access to the Power Bus on page 17 for the procedure to open the
swing-out low voltage panel behind the low voltage door.
IMPORTANT
For information on the installation site preparation, see
publication MV-QS050 .
ATTENTION: Use suitable personal protective equipment (PPE) per
local codes or regulations. Failure to do so may result in severe burns,
injury, or death. Refer to the standards such as NFPA 70E, Standard
for Electrical Safety in the Workplace and CSA Z462, Workplace
Electrical Safety Standard for safety guidance when working in and
around electrical equipment.
1/4 Turn Fasteners for Upper Low Voltage Door
1/4 Turn Fasteners for Lower Low Voltage Door