Rockwell Automation Allen-Bradley 6186M-12PN, Installation Instructions Manual, Page: 3 / 36

Industrial Performance Monitors 3
Rockwell Automation Publication 6186M-IN002C-EN-P - December 2011
About This Publication
This document provides instructions on how to install your monitor. Monitors can be installed
in a panel, rack, bench, or tabletop and are VESA mount-ready. This document does not provide
information on monitor configuration or setup.
Summary of Changes
This manual contains new and updated information. Changes throughout this revision are
marked by change bars, as shown to the right of this paragraph.
The information below summarizes the changes since the last release.
Topic Page
Added “(USB Port-Type A)” to section title 6
Added USB Port Type A illustration and callout to figure 6
Added “(USB Port-Type B)” to section title 7
Added USB Port Type B illustration and callout to figure 7
Updated website link for CE Mark certification 8
Moved “Backlight Assembly Disposal” section previously located on page 33 8
Added table with replacement mounting clips information 12
Revised instructions for panel-mounting the monitor 14
Added table with replacement analog cable and video card information 27
Added “Connecting the Optional Serial RS-232 Touch Screen Interface” section 28
Added “Connecting the USB and Optional USB Touch Screen Interface” section 28
Added “Installing the Touch Screen Driver Software” section 29
Added “Performing a Calibration” section 29
Added “Power Source Connection” title and paragraph 30
Added table with replacement AC power adapter and DIN-rail mounting accessory information 30
Revised “Secure the Cables” paragraph 32
Revised typical luminance value for 1700M monitor 33
Revised contrast ratios for 1200M and 1500M monitors 33
Revised typical response time for all monitors 33
Revised UL Listed and cUL Listed certifications 34