Rockwell Automation Publication 48CR-UM001A-EN-P - November 2019
41
Parameter Overview
Chapter 7
Media Access Control Address
Shows the following three media access control address parameters. Click the
radio button to toggle between the options. (Private Network is the default).
• Private Network: Click to have a private network for the Ethernet module.
If Private Network is selected in offline mode, the last octet of the IP
address is displayed. You can change the last octet by entering a valid value
between 1…254. This field is dimmed when the controller is in Program,
Remote Program, Remote Run, or Hard Run mode or when Private
Network is not selected.
• IP Address
(1)
: Enter the IP address of the module. This field is dimmed in
Program, Remote Program, Remote Run, and Run mode or when IP
address is not selected.
• Host Name
: Click to enter a Host Name for the module up to 64 ASCII
characters. This field appears dimmed in Program, Remote Program,
Remote Run, and Run mode or when Host Name is not selected.
Connection
Use this display to define controller-to-module behavior. You can do the
following on this display:
• Select the requested packet interval
• Choose to inhibit the module
• Configure the controller so that a loss of connection to this module causes
a major fault
• View module faults.
(1) You must enter either an IP address for the module or a host name. You do not have to enter both. These items are mutually
exclusive; once you choose one, the other is disabled.
AOP View Only*
* Not available in WebConnect
TIP
The data on this tab comes directly from the controller. This tab shows
information about the condition of the connection between the module and
the controller.