Installation Data
Communication Interface Module
Cat. No. 1784-KT2/B
15
To properly execute the diagnostic program, you must have the following:
an IBM PS/2 7541, 7561, 8550, 8555, 8560, 8570, or 8580 computer
with the 1784-KT2 installed
OR
an Allen-Bradley 6123 or 6124 computer with the 1784-KT2 installed
DOS V3.3 or greater
a PLC-2 or PLC-3 loopback connector (required for Off-Line
Communications Diagnostics tests)
For information on how to build the loopback connector, refer to section
entitled “Building Loopback Connectors”.
Below is a list of the diagnostic program files that you can find on the
Options and Diagnostics diskette:
KT2DIAG.EXE
KT2MSG.TXT
KT2DLG.TXT
@60C6.ADF
KT<DIR>
The following files are located in the KT sub-directory:
KT2ST0.BIN
KT2ST1.BIN
KT2ST2.BIN
KT2INT.BIN
KT2PLC2.BIN
KT2PLC3.BIN
KT2DHP.BIN
Important: If you have not already done so, create a backup copy of the
Options and Diagnostics diskette according to IBM instructions.
In the following example, the hard disk is referred to as C: . You are not
required to install the diagnostic program onto a hard disk. Also,
[ENTER] indicates when you must press the enter key.
To install the diagnostic program onto a hard disk, follow the steps below:
1.
Turn on the computer.
2.
When the prompt appears, type the following to select the hard disk:
c: [ENTER]
Diagnostic Program Files
Installing the Diagnostic
Program onto a Hard Disk