Rockwell Automation Publication 1609-UM009D-EN-P - February 2021
7
Bulletin 1609-D Installation Instructions
Battery Wiring and
Installation
1.
To access the battery compartment, remove the three screws and the
battery door.
2.
Remove the battery container, jumpers, and wire harness from the battery
compartment. Place the battery container and batteries onto a flat surface.
Use the provided jumper wires to connect the batteries in series. Connect
the positive terminal (red) of the battery to the negative terminal (black)
of another battery.
3.
Connect the red wire of the harness to the positive terminal (top red) and
the black wire of the harness to the negative terminal (bottom black).
ATTENTION:
Do not service the 1609-SPD without disconnecting the power
sources due to electric shock hazard for risk of severe injury or death.
IMPORTANT
The 1609-D UPS requires (3) 12V batteries, which are not included. See
for more information.
